GS615 EMDA Single Cylinder, Scissor Hoist, Electric/Hydraulic ILO of Cable
6" Pine Boards Painted Black
2-5/16" Pintle Ball Combo, 16K Rated, Mount on Plate
Pull Rope Manual Tarp/ Back Bar with Rear Hooks and Mesh Tarp
24" Cab Shield
7 Pin Flat Receptacle
Mud Flaps with Anti-Sail Brackets
INSIDE WIDTH: 84"
SIDES: One piece sides with no welded seams. 10 gauge A607 grade-50 high tensile steel with boxed top rail and fully welded boxed rear corner post. 6" side board gussets with full length rub rails, and box-type sidebraces.
RUB RAILS: Full length 45 degree deflector panels are an integral part of the sides.
FLOOR: 10 gauge two-piece high tensile steel floor with 2" floor to side radius. A607 grade-50 steel.
FRONT WALL: 10 gauge high tensile A607 grade 50 steel. Full width integral inverted V-type horizontal bracing.
TAILGATE: 3 Panel fully boxed 10 gauge high tensile A607 grade 50 steel with boxed horizontal reinforcements and sloping lower deflector. Tailgate is 6" higher than side.
TAILGATE HARDWARE: Heavy duty: Standard upper hardware is offset cast steel hinge. Lower hook is cast steel: engages tailgate pin from top. Banjo eye keeps tailgate chain in position you select.
LIGHTS & REFLECTORS: FMVSS 108 lights are standard, recessed for protection, rubber mounted and shock proof.
UNDERSTRUCTURE: Completely jig built with 3" structural channel crossmembers on 12" centers and 5" structural channel longitudinal. Crossmembers are gusseted and welded to longitudinals.